Trenchless Pipe Lining

MIAMI Trenchless Pipe Lining Company Restores Underground pipes For 50+ years

Cast iron pipes causing repeated backups?
pic-3-300x235
don't excavate floors/walls to replace them!
images-jpg-275×183--300x202
install trenchless pipe lining in 4 hours!
cast-iron-lined-pipe-300x268 (1)

The Problem

All homes in Miami built before 1972 have cast iron pipes. Over time, most of the corrosion occurs along the bottom where the water runs and causes a crack to form. The serrated edges of the crack catch on debris, which causes repeated backups. Plumbers want to excavate your floors to replace these pipes, typically costing $50,000 for a 2,000 square foot house!

 

The Solution

Since 2004, we have been relining the inside of these pipes with patented pipe restoration technology, which typically takes 3-4 days, costs 50% less than excavation, and tenants can stay home and use the plumbing 20 hours per day! We save about 400 homes per year, plus many high-rise buildings, restaurants etc. We make final video recordings of the pipes when done. See thousands of them here.

the benefits of pipe lining

  • No digging through your floors
  • Save your tile, wood or marble it’s usually impossible to find matching floor surfaces that were installed decades ago
  • Stay in your home not a hotel – pipe relining is done from outside, so you can stay in your residence
  • Speed – pipe lining takes a few days, not months as for pipe replacement by excavation

must watch! how does it work

From outside your property we open the pipe, clean out the rust, scale and roots, and then install a new “pipe liner” or sleeve which has been saturated with a self-hardening epoxy resin. The liner contains a balloon which is inflated for 3 hours while the resin becomes rock-hard. Then the balloon is removed. Alternatively, a robotic machine drives through the pipes, under camera supervision, and applies the epoxy resin to the inside of the pipe.

our two technologies

We are certified Perma-Liner and Picote installers, the two widely approved technologies in the US. The latter has been in use since 2017, and the former since 1998. We often use both technologies on the same property, depending on pipe conditions. Either way, we offer a 50-year, transferable, warranty.

highly regulated industry

The materials used in this industry are highly regulated by US and international authorities since it is used in the food industry and is used for rainwater run-off that enters rivers, lakes etc. that contain wildlife and provide a source of our potable water.

about our 50-year, transferable, warranty

Our 50-year warranty is based on tests done by independent materials testing companies, like HTS in Houston, which determine the minimum “engineered life” after measuring the flexural modulus, elongation modulus, tensile strength etc. It is transferable to new homeowners later. It also guarantees you will never have backups again!

before and after video of cast iron pipe with many holes, after spin-cast lining

We try to use spin-cast lining as much as possible due to its multiple benefits, zero risk of anything going wrong during installation, 100% pipe coverage, and least amount of pipe downtime.

commercial pipe lining for high rise buildings, restaurants and factories etc.

Businesses in Florida have last iron drains that have been rusting and scaling up for decades. Eventually the pipe will crack along the bottom or completely rust away on the floor, causing repeated backups. The old-school plumber will suggest concrete excavation and pipe replacement, which is very expensive, time consuming, messy, and will cost the business last amounts of downtime expenses!

However, our Cured In Place Pipe (CIPP) or Spin-last Lining installs in 1-4 hours. The lining is a tough, inert inner pipe that reduces diameter by only 5%, and the old pipe outside can disintegrate since the lining is a stand-alone, load-bearing pipe by itself!

High-rise buildings

The vertical sewer lines/drains (“stacks”) in tall buildings also form a crack along the length of the pipe when the corrosion eventually makes its way through the pipe. These stacks are often behind kitchen cabinets, encased in concrete walls etc., and so replacing them can be very time-consuming and expensive ($250-$300 per linear foot in South Florida).

Our pipe lining technology installs from the rooftop and so we never need to enter any of the premises. Also, pipe downtime is only 4 hours power stack, and costs about $150 per foot (varies by project size).

our technology, as featured on an episode of "designing spaces"!

This professionally-produced video features a family who just purchased their home and experienced backups right away. After snaking the pipes several times, their plumber used a video camera to diagnose the problem. Their cast-iron pipes had rough scale and “channeling” (cracked floor of pipe) which were trapping the debris. He recommended replacing the pipes through excavation. But instead, the homeowners used our technology (C.I.P.P in this case) to save their home, at 50% of the cost!

Real-Estate Transactions On Hold?

About 34% of our work involves homes for sale that have had their sewer pipes inspected and the inspector recommends that the pipes should be replaced by excavation through  the floor. Suddenly the sale is put on hold whilst the buyers decide what they should do!

Our Solution

Our estimator can perform a video inspection to determine how many feet of pipe needs to be lined, and if there are any reasons why some of the pipes cannot be lined. We then provide a firm quote for pipe lining that the buyer and seller can incorporate into their negtiations!

Scroll to Top